Description

Water and grit have a way of finding the gap around the frunk lid, and in heavy rain that means damp bags and a gritty trunk floor. This strip follows the contours of the Model 3/Y front trunk opening to close that gap, channeling rainwater away from the edge before it can run inside. It also acts as a physical barrier against leaves, dust, and road debris, so what you store up front stays clean and dry. Installation uses pre-applied adhesive tape, so there is no drilling and nothing to undo the factory seal.

Fits

Tesla Model 3 and Model Y front trunk (frunk). Shaped to the 3/Y frunk opening; not for the Model S or Model X.

Contoured to the Model 3/Y frunk opening to close the gap around the lid
Diverts rainwater away from the edge to prevent water getting inside
Blocks leaves, dust, and road debris from collecting in the trunk
Adhesive-tape install, no drilling and damage-free to remove

FAQ

Does this fit both the Model 3 and Model Y frunk?
Yes. It is shaped to the front trunk opening shared by the Model 3 and Model Y. It is not designed for the Model S or Model X.

How does it attach, and will it damage the paint?
It uses pre-applied adhesive tape that presses onto the frunk edge. There is no drilling, and it removes cleanly without harming the factory finish.