Description
The front hood intake on the Model Y pulls outside air into the HVAC system, and it also pulls in whatever is blowing around: leaves, pine needles, seed pods, and grit. Once that debris gets past the grille it clogs the cabin filter early and can settle where you cannot easily reach it. This cover clips over the intake opening and screens out the junk before it gets in, while its open pattern lets air pass so cabin ventilation and airflow stay normal. It clips on with no drilling, glue, or cutting, so nothing on the car is altered and you can pull it off to clean it.
Fits
Tesla Model Y, 2020 through 2025. Sized for the Model Y front hood intake only; not for Model 3, S, or X.
- Screens leaves, needles, and grit out of the front hood air intake
- Open vent pattern keeps HVAC airflow unobstructed
- Clip-on fit installs with no drilling, glue, or cutting
- Removes in seconds so you can clear debris and rinse it clean
- Shaped for the Model Y intake, 2020-2025 model years
FAQ
Will this block or reduce my air conditioning airflow?
No. The cover has an open vent pattern that screens out debris while letting air pass, so HVAC airflow stays the same.
Does installing it require drilling or leave marks?
No. It uses a clip-on design that attaches to the existing intake opening with no drilling, adhesive, or cutting, and lifts off without leaving damage.
Does it fit the Model 3 or other Tesla models?
No. It is shaped specifically for the Model Y front hood intake for 2020-2025 and will not fit the Model 3, S, or X.
Reviews
There are no reviews yet.