Description

The Model Y and Model 3 push air through a long slot across the dashboard, and depending on where you sit that stream can hit you straight in the face or dry out your eyes on a long drive. These two silicone strips shape the vent to send the air on a gentler angle instead of a direct draft. They’re molded to match the shape of the dashboard outlets, so they press into place and hold without adhesive, clips, or any cutting. The silicone is soft enough to sit flush, and it’s waterproof and holds its shape rather than sagging over time.

Fits

Tesla Model Y and Model 3, matched to the dashboard air outlet shape. Set of 2, one per vent side.

Redirects the dashboard air stream so it stops blowing straight at your face
No-damage fit: presses into the vent shape with no adhesive or drilling
Molded silicone matched to the Model Y and Model 3 outlets for a flush look
Waterproof and holds its shape, resists sagging and deformation over time
Set of 2 covers both sides of the dashboard vent

FAQ

Will these fit both the Model Y and the Model 3?
Yes. They are molded to match the dashboard air outlet shape shared by the Model Y and Model 3.

Do they need glue or clips to stay in place?
No. Each strip is shaped to press into the vent and grip on its own, so there is no adhesive and nothing to cut or drill.

Will they block the airflow?
No. They redirect the stream to a softer angle rather than reducing it, so you still get full airflow without the direct draft.