Description
Slide a jack under a Tesla in the wrong place and you can crack the battery pan or bend a pinch weld, both expensive mistakes. These pucks fix that. Each one is 3D laser-measured and molded to drop straight into the car’s factory lift point, so the jack or lift arm loads the reinforced spot the way the chassis was designed for. They are cut from vulcanized rubber, which is firm enough to carry the weight without crushing and grippy enough to keep the pad from sliding as the car goes up.
Fits
Tesla Model 3, Model Y, Model S and Model X. Molded to the factory jack points shared across the lineup.
- Seats into the factory jack point so the load stays on the reinforced lift location, not the battery pan or pinch weld
- 3D laser-measured and molded for a precise, non-slip fit at the lifting spot
- Vulcanized rubber holds the weight without crushing or tearing
- Works with a floor jack, jack stands, or a two-post lift
- Covers Model 3, Y, S and X, so one set suits the whole garage
FAQ
Will these fit my Model 3 and Model Y?
Yes. They are molded to the factory jack points, which are the same across Model 3, Y, S and X, so the same puck works on all four.
Do they work with jack stands and a lift, not just a floor jack?
Yes. The puck sits in the car’s lift point and provides a solid, protected surface for a floor jack, jack stands, or a two-post lift arm.
Will the rubber crush or slip under the car’s weight?
No. It is vulcanized rubber, firm enough to carry the load without crushing and grippy enough to keep the jack pad from sliding as you raise the car.
Reviews
There are no reviews yet.