Description
The paint around the charging port takes a beating over time: every plug-in drags the connector across it, and cables swing back and back-in leave fine scratches and swirl marks. These two films lay a clear TPU shield over that spot on the tail-light side so the abrasion hits the film instead of the finish. The material is cut to the port’s shape, so it follows the contour without bunching and stays close to invisible once it is on.
Fits
Tesla Model 3 (2021-2024) and Model Y (2021-2025), tail-light-side charging port. Cut for these years; confirm your port location before ordering if you have a different model or a later refresh.
- Clear TPU layer takes the scratches and cable scuffs instead of your paint
- Precut to the charging port shape for an exact, contoured fit
- Installs by hand in minutes, no heat gun or special tools needed
- Stays low-profile and near-invisible so the panel still looks stock
- Set of 2 covers a spare or a second Tesla
FAQ
Do I need any tools or heat to install this?
No. The film is precut and goes on by hand. Clean the area first, peel, and press it into place; no heat gun or trim tools required.
Will it be noticeable on the car?
Not really. The TPU is clear and thin, so once it is smoothed down it sits low against the panel and keeps the port area looking stock.
Does this fit the Model 3 Highland or the 2025 Model Y Juniper?
It is cut for Model 3 2021-2024 and Model Y 2021-2025. If you have a later refresh, check that your charging port matches before ordering.
Reviews
There are no reviews yet.